mnfasad.blogg.se

1. #How to configure hirschmann switch hiper ring software
2. #How to configure hirschmann switch hiper ring series

Protocol is enabled, you must disable that first instead. RSTP on each ring port before configuring ERPS. In the default switch configuration, this example shows disabling Because RSTP is the spanning-tree protocol enabled Spanning-tree protocols and ERPS cannot both be configured This particular ERP instance-the blocked port on Cobia is marked State, the RPL end blocks the control VLAN and data channel VLAN for Of Jas5-esc is configured as the RPL neighbor interface. Ge-0/0/0 configured as an RPL end interface. The east interface of each switch is connected with the west Named erp1 on four switches connected in a ring by trunk ports asĪre trunk ports, the VLAN named erp-control-vlan-1 is used for erp1 This example creates one protection ring (called a node ring) Nontrunk ports use the physical link as the controlĬhannel and protocol data units (PDUs) are untagged, with no VLAN When multiple ERPS instances are configuredįor a ring, there are multiple sets of ring protection links (RPLs)Īnd RPL owners on the ERPS link, and a different channel is blockedįor each instance. Trunk ports on switches use a VLAN to create individualĬontrol channels for ERPS. See Table 1 for a list of the interface names used in this example. See Table 1 for a list of the interfaceĬonfigured two VLANs ( erp-data-1 and erp-data-2) with IDs 101 and 102, respectively, on all four switches and associatedīoth the east and west interfaces on each switch with erp-data-1 and erp-data-2.

#How to configure hirschmann switch hiper ring series

See Configuring VLANs for EX Series Switches.

#How to configure hirschmann switch hiper ring software

Junos OS Release 12.1 or later without support for theĮnhanced Layer 2 Software (ELS) configuration style.Ĭonfigured two trunk interfaces on each of the four switches.Ĭonfigured the same VLAN ( erp-control-vlan-1) with ID 100 on all four switches and associated two network interfacesįrom each of the four switches with the VLAN. Moves to an idle state on the non-RPL switch The output from the CLIĬommand 'show protection-group ethernet-ring node-state detail' listsĪ WTB setting but that setting has no effect.ĭuring initial state machine initialization on EX2300Īnd EX3400 switches, both ERPV1 ring ports move to a discarding stateĭuring ERPV1 initial state machine initialization on EX2300Īnd EX3400 switches, the Automatic Protection Switching (APS) state You make to the WTB setting has no effect. The Wait To Block Timer (WTB) is always disabled on EX2300Īnd EX3400 switches because it is not supported in ERPSv1. Wait to Restore (WTR) configuration values on EX2300 and Switches deviates from the ERPV1 ITU standard in the following ways: On both EX2300 and EX3400 switches, operation of ERPS on those two Because Junos uses an ERPV2 state machine for ERPV1 support